His advice is then vital before you do any more prepping. Key is get your quotes, see their work and pick the best quality tradesman. Or better still, fibreglass rendering mesh cut to size, overlapping the joint by 100 mm and bedded in. This is covered fully with 100mm Fibatape overlapped. 0:00 7:58 How to Patch a Plaster and Lath Ceiling Ask This Old House This Old House 1.94M subscribers Subscribe 679K views 4 years ago Ask This Old House general contractor Tom Silva helps. If, as the lads say, your plasterer says take it down, the you can cut well away from the cornice to avoid damage to it, then cut a bit closer until you are about 250mm away. The above is possible if there are no areas that will cause a bump in the plasterboard.ie you can screw the boards up tight. You could take any major loose spots and fill them with a layer of board or coat of bonding to receive the plasterboard. Ie you end up witha 250 recessed band around the perimeter. The edge of the board is fixed with an edging bead to give it a finish, and make a feature of the cornice instead of losing the definition of the ceiling member. If what is up there isn't too bumpy, then I would overboard, leaving a 250mm gap from the cornice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |